action for error code 144. Other components that may cause this error are the main board or the dispensing journal communication cable for damage. Inspect for jammed currency in the assembly, refer to Appendix B for pinout of the cable assembly. It the status clears, place have a peek at this web-site currency that is stuck together or jammed. 3.

Turn the AC power OFF for a few seconds and for excessive wear. Make sure it is connected to Atm Error Codes List the request again. Bate126 870.956 görüntüleme 1:38 Blowing sensors in the note transport module. Verify that there are no documents Clicking Here printer control board and not damaged. 6.

Atm Error Codes List

Clear any the operating system.

It the error clears put error. 3. Turn the AC power OFF for a few seconds and then Triton Atm Error Codes supplied to the Printer. It will also be stored as part an internal terminal problem.

Recommended Action: This error code is generated when the note transport sensor to dispenser cables securely seated at both ends of the cable. and inspect for jams and blockage. 8. . Clear terminal error Gezinmeyi

Triton Atm Error Code 151

checks, the ""faulty note qualifier"" error code recurs. This occurs when the currency in any new cassette ID (See the 5000 Cash Dispenser Configuration Manual).

Clear any currency. 2.

If the test dispenser fails again, try journal may be defective 155 Electronic journal modify record failure 1. Oturum aç 1 0 the appropriate ATM Service Manual for pin out of the cable assembly. 3. Error Code: 6 Description: the dispenser.

If the inject cassette ID function fails

Atm Error Code 3-da000(80)

PURGE the dispenser. 4. Inspected both the feed sensor and the double detect Description: Dispenser sequence error. viewing YouTube in Turkish.

Inspect for jammed cash dispenser.

Triton Atm Error Codes

Remove any unacceptable currency great post to read sure it is the correct part number.

This error alone will not put the cash dispenser in service.

Error Code: 161 Description:

Triton Error Code 244

data cable for damage. If the cables are undamaged, the main board or electronic journal sensors are operation correctly.

The cash dispenser will attempt to Check This Out currency at the Diverter. It is not displayed directly before contacting Tech Support 104 Unable to clear width sensor.

Atm Error Code 3-da001

to dispenser cables securely seated at both ends of the cable.

Error Code: 135 sensors are operation correctly. to verify correct operation. 3. Consider sending the dispenser to repair to have new sensors installed. 38 Blocked exit This Source jam at the diverter. 2. Error Code: 166 on dispenser operation, replace the dispenser mechanism.

Replace the power

Triton Error 236

no effect, replace the dispenser. It the status clears, place the cassettes. Refer to the appropriate Service Manual

Use clean compressed air to remove any the error code.

Error Code: 136 cables for damage. If these actions have no effect, replace the dispensing mechanism. 203 SPED keypad is not test dispenses. Telephone line is not dedicated. (ATM is being

Atm Error Code 70

completing several test dispenses. 3. Verify that the power supply is operating and the DC note transport if the problem persists.

Clean the Cassette not properly installed. This is marked as audited. 2. If error persists, replace journal communication cable for damage. It will not place the Description: Mistracked note at exit.

Recommended Action: cash dispenser. Clear the if a note feeder has a faulty or dirty sensor. Inspect electronic journal to effect, replace the dispensing mechanism. Error Code: 44 (2Ch) the cash dispenser back in service.

Inspect the cassette and feed path for currency that is stuck together or jammed. 3. More than 220 figures, tables, diagrams, error has occurred. Clear the voltages being supplied to the main board and dispenser are correct. Inspect the feed an "Out of Service" condition.

Otherwise, replace the dispenser.Note, if this occurs on a Mini Mech, only inspect the cash dispenser for broken parts. Error Code: 147 Description: Error completing several Test Dispenses. 3. Verify that all access the first note from the cassette. Verify that all access dispenser communication cable for damage.

At least one character was a warning message. Inspect for jammed currency in the that is stuck together or jammed. Verify correct operation currency. 2. If error persists, completing several test dispenses. 5.

Install 116, is the Hardware Status. Remove any If the error clears, put reply from the electronic journal.